•
In the SMTP Server field, enter the name of the SMTP server to which the DFL-1000 should send
email.
The SMTP server can be located on the private network, on the DMZ network or on the Internet.
•
In the SMTP User field, enter the email address of a valid user of the SMTP server (for example,
user@D-Link.com).
This is the address that the mail will originate from.
•
Enter up to 3 destination email addresses in the Email To fields.
These are the email addresses that the DFL-1000 sends email alerts to.
•
Click Apply to save the email alert configuration.
•
Make sure that the DNS server settings are correct for the DFL-1000. See
.
Because the DFL-1000 uses the SMTP server name to connect to the mail server, it must be able to
look up this name on your DNS server.
Example alert email settings:
Testing email alerts
You can test your email alert settings by sending a test email.
•
Go to
System > Config > Alert Mail
.
•
Click Test to send test email messages from the DFL-1000.
DFL-1000 User’s Manual
69
