CHAP v2 authentication protocol. (Default: Yes)
MPPERC456
Use an RC4 56 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
MPPERC4128
Use an RC4 128 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
IPPool
A range, group or network that the PPTP/L2TP server will use as
IP address pool to give out IP addresses to the clients from.
DNS1
IP of the primary DNS server. (Optional)
DNS2
IP of the secondary DNS server. (Optional)
NBNS1
IP of the primary Windows Internet Name Service (WINS) serv-
er that is used in Microsoft environments which uses the Net-
BIOS Name Servers (NBNS) to assign IP addresses to NetBIOS
names. (Optional)
NBNS2
IP of the primary Windows Internet Name Service (WINS) serv-
er that is used in Microsoft environments which uses the Net-
BIOS Name Servers (NBNS) to assign IP addresses to NetBIOS
names. (Optional)
AllowedRoutes
Restricts networks for which routes may automatically be added.
(Default: all-nets)
MPPEAllowStateful
Allow usage of Stateful MPPE (less secure, use only for compat-
ibility). (Default: No)
MemberOfRoutingTable
All or Specific. (Default: All)
RoutingTable
Specifies the PBR table to insert the interface IP route into. It
also means that the specified routing table will be used for all
routing lookups, unless overridden by a PBR rule. (Default:
main)
ProxyARPAllInterfaces
Always select all interfaces, including new ones, for publishing
routes via Proxy ARP. (Default: No)
ProxyARPInterfaces
Specifies the interfaces on which the security gateway should
publish routes via Proxy ARP. (Optional)
Comments
Text describing the current object. (Optional)
3.30.8. LoopbackInterface
Description
Loopback interfaces will take all packets sent through them and pass them back up a different inter-
face as newly received packets.
Properties
Name
Specifies a symbolic name for the interface. (Identifier)
LoopTo
Loop back interface. (Optional)
3.30.8. LoopbackInterface
Chapter 3. Configuration Reference
141
