36
Administrative users
Click on
Firewall
in the menu bar, and then click
Users
below it. This will show all the
users, and the first section is the administrative users.
The first column shows the access levels,
Administrator
and
Read-only
. An
Administrator
user can add, edit and remove rules, change settings of the DFL-700 and so on. The
Read-
only
user can only look at the configuration. The second column shows the users in each
access level.
Add Administrative User
Follow these steps to add a new administrative user.
Step 1.
Click on
add
after the type
of user you would like to add, Admin
or Read-only.
Step 2.
Fill in
User name;
make
sure you are not trying to add one
that already exists.
Step 3.
Specify the password for
the new user.
Click the
Apply
button below to apply the setting or click Cancel to discard changes.
Note:
The user name and password should be at least six characters long. The user
name and password can contain numbers (0-9) and upper and lower case letters (A-Z, a-
z). Special characters and spaces are not allowed.
Summary of Contents for DFL-700 - Security Appliance
