D-Link DFM 562I Controllerless Modem Card User’s Guide
3
Modems connected to the Australian telecommunications network must be marked in accordance with the
Labeling Notice. This modem has been specifically configured to ensure compliance with the ACA
Standards. Do not adjust your modem or software outside the values indicated as below. To do so would
result in your modem being operated in a non-compliant manner.
Modem Commands:
Command Default Permissible Range
ATA
-
Do not use
ATB
B0 Do not set to B1
AT&G
&G0 &G2
AT&P
&P0 &P1
ATSn
see table below
S register Default Permissible Range
s6 2 2 to 6
Call Attempts/Retries:
Applications software shall be configured so that no more than 3 attempts are made to
establish a connection to a given number (Note: if the modem can detect service tones, up to 10 attempts
can be made). If the call sequence is unsuccessful, there shall be a delay of at least 30 minutes before
attempting to call the number again.
Failure to set the modem and any application software used with the modem, to the values
shown as above will result in the modem being operated in a non-compliant manner.
Consequently, this would be in violation of the Labeling Notice for this equipment, and the
Telecommunications ACT 1997 prescribes penalties for the connection of non-compliant equipment.
WARNING
FOR SAFETY REASONS, ONLY CONNECT EQUIPMENT WITH A
TELECOMMUNICATIOS COMPLIANCE LABEL. THIS INCLUDES
CUSTOMER EQUIPMENT PREVIOUSLY LABELLED
PERMITTED OR CERTIFIED.
WARNING
ONLY CONNECT EQUIPMENT WITH A TELECOMMUNICATIONS
COMPLIANCE LABEL
Summary of Contents for DFM 562I
Page 47: ...D Link DFM 562I Controllerless Modem Card User s Guide 47 5 Click OK to end this procedure ...
Page 50: ...D Link DFM 562I Controllerless Modem Card User s Guide 50 5 Click OK to end this procedure ...
Page 54: ...D Link DFM 562I Controllerless Modem Card User s Guide 54 3 Click Close to end this procedure ...
