D-Link DGS-1010MP, Installation Manual

  3

E

N

G

LI

S

H

3.  Attach the terminal lug ring at the other end 

of the grounding cable to an appropriate 

grounding source.

4.  Verify that the connection between the 

grounding connector on the switch and the 

grounding source is secure.

Powering On the Switch

1.  Connect the power cord to the power connector 

on the switch.

2.  Plug the other end of the power cord into a 

nearby power socket.

Attaching the Power Cord Retainer

To prevent the power from accidently being 

disconnected, it is recommend to install the included 

power cord retainer. 
1.  With the smooth side facing up, insert the tie into 

the opening below the power socket.

Figure 7

2.  Plug the power cord into the power socket on 

the switch.

Figure 8

3.  Slide the retainer through the tie until it has 

reached the end of the power cord.

Figure 9

4.  Wrap the tie of the retainer strip around the 

power cord and back into the retainer to lock it. 

Fasten the tie until the power cord is secured.

Figure 10

Connecting to the Network

The switch can be integrated into the network 

through one of the following connection methods:

Switch to End Node or Powered Device

Use a standard Ethernet cable to connect the switch 

to PCs with an 10/100/1000 Mbps RJ-45 interface, 

or connect and power remote IEEE 802.3af/at-

compliant devices, such as IP cameras or IP phones 

using PoE.