D-Link DGS-1024D - Switch, Quick Installation Manual

22

E

N

G

LI

S

H

Installing a Power Cord 

Retainer 

Installation of a power cord retainer is recommended 

to prevent accidental removal of the AC power cord.

A. Insert a tie wrap with the rough side facing down 

into the hole below the power socket.

Insert tie wrap

B. Connect the AC power cord into the AC power 

inlet of the switch.

Connect the power cord to the switch

C. Attach the retainer to the tie wrap and slide it up to 

the end of the cord.

Attach the retainer to the tie wrap

D. Wrap the retainer around the power cord and 

place the free end into the fastener.

Wrap the retainer around the power cord

E. Fasten the retainer by pulling on it until secure.

Secure the power cord

F. Connect the AC power cord to an electrical outlet.

Connecting the DGS-1016D/

DGS-1024D to your network

A. Power

The switch can be used with AC power sources 100 

- 240 VAC, 50 - 60 Hz. The switch’s power supply 

will adjust to the local power source automatically 

and may be turned on without having any or all LAN 

segment cables connected.

B. Ethernet

These  ports  support  network  speeds  of  10  Mbps, 

100  Mbps,  or  1000  Mbps,  and  can  operate  in 

half-duplex and full-duplex transfer modes. These 

ports  also  support  automatic  MDI/MDIX  crossover 

detection, which gives the switch true “plug and 

play” capabilities. Just connect any network cable 

between the switch and the device, and the switch 

will automatically detect the settings of the device and 

adjust itself accordingly.