2
E
N
G
LI
S
H
Front Panel Connectors
Figure 2
#
Item
Description
1
Ports 1 - 4 8
These are 10/100/1000 Mbps ports that can
be used to connect to any device using a
standard Category 5/6/7 RJ-45 Ethernet cable.
2
Ports 49 - 52
These are 10 Gbps SFP+ ports that can be used
to connect to other switches using compatible
SFP+ adapters. Either fiber or Direct Attach
Cables (DACs) can be used.
Table 2
Rear Panel Connectors
1
Figure 3
#
Item
Description
1
2
Switch GND
This is used to connect the switch to ground.
3
Power Cord
Retainer Slot
This is used for securing the power cord
retainer to the switch.
Power Input
This is used to connect the power cable to the
switch.
Table 3
Hardware Installation
Before You Begin
Observe the following precautions to help prevent
shutdowns, equipment failures, and personal injury:
• Install the DGS-1052X in a cool and dry place.
Refer to the technical specifications in the
user manual for the acceptable operating
temperature and humidity ranges.
• Install the switch in a site free from strong
electromagnetic sources, vibration, dust, and
direct sunlight.
• Leave at least 10 cm of space at the left and right-
hand side of the switch for ventilation.
Before You Begin
This Quick Installation Guide gives you step-by-step
instructions for setting up your 48 Port 10/100/1000
Mbps + 4 Port 10 Gbps SFP+ Unmanaged Switch.
The model you have purchased may appear slightly
different from the one shown in the illustrations.
Package Contents
This DGS-1052X package should include the
following items:
• DGS-1052X
• Power cord
• Rack mount kit and rubber feet
• Quick Installation Guide
If any of the above items are damaged or missing,
please contact your local D-Link reseller.
Hardware Overview
LED Indicators
Figure 1
#
LED
Status
Description
1
Power
Solid
green
The device is powered on.
Off
The device is powered off.
2
Link/Act/
Speed
Ports
1 - 48
Solid
green
There is an active link on the
corresponding port operating at 1000
Mbps.
Blinking
green
There is traffic on the corresponding port
at 1000 Mbps.
Solid
amber
There is an active link on the
corresponding port operating at 10/100
Mbps.
Blinking
amber
There is traffic on the corresponding port
at 10/100 Mbps.
3
Link/Act/
Speed
Ports
49 - 52
Solid
green
There is an active link on the
corresponding port operating at 1/10 Gbps.
Blinking
green
There is traffic on the corresponding port
at 1/10 Gbps.
Table 1
1
2
3
1
2
2
3
