5 Configuration
D-Link Web Smart Switch User Manual
4
4
7
7
Figure 5.49 – L2 Functions > Multicast > Multicast Forwarding
VID:
The VLAN ID of the VLAN to which the corresponding MAC address belongs.
Multicast MAC Address:
The MAC address of the static source of multicast packets. This must be a
multicast MAC address.
Port Settings:
Allows the selection of ports that will be members of the static multicast group and ports
either that are forbidden from joining dynamically, or that can join the multicast group dynamically, using
GMRP.
Member -
The port is a static member of the multicast group.
None -
No restrictions on the port dynamically joining the multicast group. When
None
is chosen,
the port will not be a member of the Static Multicast Group.
L2 Functions > Multicast > Multicast Filtering Mode
The
Multicast Filtering Mode
function allows users to select the filtering mode for IGMP group per VLAN
basis.
Figure 5.50 – L2 Functions > Multicast > Multicast Filtering Mode
VLAN ID:
Specifies the VLAN ID.
Filtering Mode:
Forward Unregistered Groups:
The multicast stream will be forwarded based on the register table
in registered group, but it will be flooded to all ports of the VLAN in unregistered group.
Filter Unregistered Groups:
The registered group will be forwarded based on the register table and
the unregister group will be filtered.
Click
Apply
to make the change effective.
L2 Functions > SNTP > Time Settings
SNTP or Simple Network Time Protocol is used by the Switch to synchronize the clock of the computer. The
SNTP settings folders contain two windows: Time Settings and TimeZone Settings. Users can configure the
time settings for the switch, and the following parameters can be set or are displayed in the Time Settings
page.
Summary of Contents for DGS-1210-10P
Page 1: ......
Page 32: ...5 Configuration D Link Web Smart Switch User Manual 2 27 7 Figure 5 16 User Guide Micro Site...
Page 109: ......
