5 Configuration
D-Link Web Smart Switch User Manual
7
7
9
9
System Power Status:
Displays the system power status of device.
Total PoE Power Budget:
Displays the total PoE power budget of this switch.
Power Used:
Displays the current used power of the switch.
Power Left:
Displays the spare power of the switch.
The percentage of system power supplied:
Displays the percentage of system power supplied of
the switch.
PoE > PoE Port Settings (DGS-1210-10P/28P only)
DGS-1210-10P/28P supports Power over Ethernet (PoE) as defined by the IEEE specification. It supplies
power to PD device up to 15.4W for all ports or 30W for port 1~4, meeting IEEE802.3af standards and pre-
802.3at standards.
DGS-1210-10P/28P works with all D-Link 802.3af or 802.3at capable devices. The Switch also works in PoE
mode with all non-802.3af capable D-Link AP, IP Cam and IP phone equipment via the PoE splitter DWL-
P50.
IEEE 802.3at defined that the PSE provides power according to the following classification:
Class Usage
Output power limit by PSE
0
Default
15.4W
1
Optional
4.0W
2
Optional
7.0W
3
Optional
15.4W
4
Reserved 30W
The PoE port table will display the PoE status including, Port Enable, Power Limit, Power (W), Voltage (V),
Current (mA), Classification, Port Status. You can select
From Port
/
To Port
to control the PoE functions of
a port. DGS-1210-10P/28P will auto disable the ports if port current is over 375mA in 802.3af mode or
625mA in pre-802.3at mode.
Note:
The PoE Status information of Power
current, Power Voltage, and Current is the power
usage information of the connected PD; please
"Refresh" to renew the information.
Figure 5.102 – PoE > PoE Port Setting
From Port/To Port:
Specifies the PoE function of a port or ports.
State:
Select “Enabled” or “Disabled” to configure PoE function for designated port(s). Default is
Enabled
.
Summary of Contents for DGS-1210-10P
Page 1: ......
Page 32: ...5 Configuration D Link Web Smart Switch User Manual 2 27 7 Figure 5 16 User Guide Micro Site...
Page 109: ......
