5 Configuration
D-Link Web Smart Switch User Manual
System > Port Settings
In the Port Setting page, the status of all ports can be monitored and adjusted for optimum configuration. By
selecting a range of ports (
From Port
and
To Port
), the
Speed
can be set for all such ports, by clicking
Apply
. To refresh the information table to view the latest Link Status and Priority, press the
Refresh
button.
Figure 42 – System > Port Setting
Speed:
Gigabit Fiber connections can operate in Auto Mode or Disable. Copper connections can operate in
Forced Mode settings (100M Full, 100M Half, 10M Full, 10M Half), Auto, or Disable. 100M Fiber connections
support 100M Full Force Mode, Auto or Disable. The default setting for all ports is
Auto
.
NOTE:
Be sure to adjust port speed settings
appropriately after changing connected cable
media types.
Link Status:
Reporting
Down
indicates the port is disconnected.
Priority:
Displays each port’s 802.1p QoS priority level for received data packet handling. Default setting for
all ports is
Middle
. You can change the priority settings in
Qos > 802.1p Default Priority
NOTE:
When the Combo Fiber port and the
Copper ports are both connected, the Fiber port
will take precedence over the Copper ports,
meaning the Fiber port will be the only connection.
System > SNMP Settings
Simple Network Management Protocol (SNMP) is an OSI Layer 7 (Application Layer) designed specifically
for managing and monitoring network devices. SNMP enables network management stations to read and
modify the settings of gateways, routers, switches, and other network devices. Use SNMP to configure
system features for proper operation, monitor performance and detect potential problems in the Switch or
LAN.
Managed devices that support SNMP include software (referred to as an agent), which runs locally on the
device. A defined set of variables (managed objects) is maintained by the SNMP agent and used to manage
the device. These objects are defined in a Management Information Base (MIB), which provides a standard
presentation of the information controlled by the on-board SNMP agent. SNMP defines both the format of the
MIB specifications and the protocol used to access this information over the network.
The default SNMP setting is disabled. Click enable, then
Apply
, to set Community Settings.
2
2
6
6
