DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
111
locking and 802.1X must not be enabled on the trunk group. Further, the LACP aggregated links must all
be of the same speed and should be configured as full duplex.
Load balancing is automatically applied to the ports in the aggregated group, and a link failure within the
group causes the network traffic to be directed to the remaining links in the group.
The Spanning Tree Protocol will treat a link aggregation group as a single link, on the switch level. On the
port level, the STP will use the port parameters of the Master Port in the calculation of port cost and in
determining the state of the link aggregation group. If two redundant link aggregation groups are
configured on the Switch, STP will block one entire group; in the same way STP will block a single port
that has a redundant link.
NOTE:
If any ports within the trunk group become disconnected, packets intended for the
disconnected port will be load shared among the other linked ports of the link aggregation
group.
This window is used to view and configure the link aggregation settings.
To view the following window, click
L2 Features > Link Aggregation
, as shown below:
Figure 5-35 Link Aggregation window
The fields that can be configured for
Link Aggregation
are described below:
Parameter
Description
System Priority
Enter the system’s priority value used here. This value must be
between 1 and 65535. By default, this value is 32768. The system
priority determines which ports can join a port-channel and which ports
are put in the stand-alone mode. The lower value has a higher priority.
If two or more ports have the same priority, the port number
determines the priority
Load Balance Algorithm
Select the load balancing algorithm that will be used here. Options to
choose from are
Source MAC
,
Destination MAC
,
Source
Destination MAC
,
Source IP
,
Destination IP
, and
Source
Destination IP
. By default, this option is
Source MAC
.
Click the
Apply
button to accept the changes made.
The fields that can be configured for
Channel Group Information
are described below:
Summary of Contents for DGS-1510 Series
Page 1: ...1...
