DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
175
After selecting the
UDP
option as the
Protocol Type
, the following section will appear.
Figure 8-7 ACL Configuration Wizard (Add Rule for IPv4 ACL) UDP window
The
dynamic
fields that can be configured are described below:
Parameter
Description
Source
Select and enter the source information here. Options to choose from
are
Any
,
Host
, and
IP
. When the
Any
option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the
Host
option is selected, enter the source host’s IP address here.
When the
IP
option is selected, the
Wildcard
option will also be
available. Enter the group of source IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Destination
Select and enter the destination information here. Options to choose
from are
Any
,
Host
, and
IP
. When the
Any
option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the
Host
option is selected, enter the destination host’s IP
address here. When the
IP
option is selected, the
Wildcard
option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Source Port
Select and enter the source port value here. Options to choose from
are
=
,
>
,
<
,
≠
, and
Range
. When selecting the
=
option, the specific
selected port number will be used. When selecting the
>
option, all
ports greater than the selected port, will be used. When selecting the
<
option, all ports smaller than the selected port, will be used. When
selecting the
≠
option, all ports, excluding the selected port, will be
Summary of Contents for DGS-1510 Series
Page 1: ...1...
