DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
15
The fields that can be configured for
Error Disable Trap Settings
are described below:
Parameter
Description
Asserted
Select this option to enable or disable the notifications when entering
into the error disabled state.
Cleared
Select this option to enable or disable the notifications when exiting
from the error disabled state.
Notification Rate
Enter the number of traps per minute. The packets that exceed the
rate will be dropped. The value is between 0 and 1000.
Click the
Apply
button to accept the changes made.
The fields that can be configured for
Error Disable Recovery Settings
are described below:
Parameter
Description
ErrDisable Cause
Select the error disable causes here. Options to choose from are
All
,
Port Security
,
Storm Control
,
BPDU Attack Protection
,
Dynamic
ARP Inspection
,
DHCP Snooping
, and
Loopback Detect
.
State
Select this option to enable or disable the auto-recovery for an error
port caused by the specified cause.
Interval
Enter the time between 5 and 86400 seconds to recover the port.
Click the
Apply
button to accept the changes made.
Jumbo Frame
This window is used to view and configure the Jumbo Frame size and settings. The Switch supports
jumbo frames. Jumbo frames are Ethernet frames with more than 1,518 bytes of payload. The Switch
supports jumbo frames with a maximum frame size of up to 9216 bytes.
To view the following window, click
System > Port Configuration > Jumbo Frame
, as shown below:
Figure 3-8 Jumbo Frame window
Summary of Contents for DGS-1510 Series
Page 1: ...1...
