DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
63
Figure 4-44 File System - Copy window
When copying a file to the file system of this switch, the user must enter the
Source
and
Destination
path. Tick the
Replace
check box to replace the current running configuration with the indicated
configuration file.
Click the
Apply
button to initiate the copy.
Click the
Cancel
button the discard the process.
Physical Stacking
The Switch supports switch stacking, where a set of 6 switches can be combined to be managed by one
IP address through Telnet, the Web User Interface, the RJ45 console port, or through SNMP. Each
switch of this series has two stacking ports located at the front of the device, which can be used to
connect other devices and make them stack together. After adding these stacking ports, the user may
connect these ports together using fiber cables or Direct Attach Cables (DAC) in one of two possible
topologies.
Duplex Chain
– As shown in Figure 4-45, The Duplex Chain topology stacks switches together in a
chain-link format. Using this method, data transfer is only possible in one direction and if there is a break
in the chain, then data transfer will obviously be affected.
Duplex Ring
– As shown in
Error! Reference source not found.
, the Duplex Ring stacks switches in a
ring or circle format where data can be transferred in two directions. This topology is very resilient due to
the fact that if there is a break in the ring, data can still be transferred through the stacking cables
between switches in the stack.
Summary of Contents for DGS-1510 Series
Page 1: ...1...
