DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
276
Parameter
Description
Trap Rate
Enter the number of traps per second. The range is from 0 to 1000.
The default value 0 indicates an SNMP trap to be generated for every
security violation.
Click the
Apply
button to accept the changes made.
The fields that can be configured for
Port Security System Settings
are described below:
Parameter
Description
System Maximum Address
Enter the maximum number of secure MAC addresses allowed. If not
specified, the default value is No Limit. The valid range is from 1 to
6656. Tick the
No Limit
checkbox to allow the maximum number of
secure MAC address.
Click the
Apply
button to accept the changes made.
Port Security Port Settings
This window is used to view and configure the port security port settings.
To view the following window, click
Security > Port Security > Port Security Port Settings
, as shown
below:
Figure 9-2 Port Security Port Settings window
The fields that can be configured are described below:
Parameter
Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
State
Select to enable or disable the port security feature on the port(s)
specified.
Maximum
Enter the maximum number of secure MAC addresses that will be
allowed on the port(s) specified. This value must be between 1 and
6656. By default, this value is 32.
Violation Action
Select the violation action that will be taken here. Options to choose
Summary of Contents for DGS-1510 Series
Page 1: ...1...
