DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
285
(PAE) authenticator.
Server Timeout
Enter the server timeout value here. This value must be between 1 and
65535 seconds. By default, this value is 30 seconds.
Supp Timeout
Enter the supplicant timeout value here. This value must be between 1
and 65535 seconds. By default, this value is 30 seconds.
TX Period
Enter the transmission period value here. This value must be between
1 and 65535 seconds. By default, this value is 30 seconds.
Click the
Apply
button to accept the changes made.
Authentication Session Information
This window is used to view and configure the authentication session information.
To view the following window, click
Security > 802.1X > Authentication Session Information
, as shown
below:
Figure 9-14 Authentication Session Information window
The fields that can be configured are described below:
Parameter
Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
Click the
Init by Port
button to initiate the session information based on the selections made.
Click the
ReAuth by Port
button to re-authenticate the session information based on the selections made.
Authenticator Statistics
This window is used to view and clear the authenticator statistics.
To view the following window, click
Security > 802.1X > Authenticator Statistics
, as shown below:
Figure 9-15 Authenticator Statistics window
Summary of Contents for DGS-1510 Series
Page 1: ...1...
