DGS-3100 Gigabit Ethernet Switch Manual
Figure 1–2. Boot Screen
The Switch’s MAC address can also be found in the Web management program on the Device Information
window on the Configuration menu.
The IP address for the Switch must be set before it can be managed with the Web-based manager. The Switch
IP address can be automatically set using BOOTP or DHCP protocols, in which case the actual address
assigned to the Switch must be known.
The IP address may be set using the Command Line Interface (CLI) over the console serial port as follows:
1.
Starting at the command line prompt, enter the commands config ipif System vlan default ipaddress
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy. Where the x’s represent the IP address to be assigned to the IP interface named
System and the y’s represent the corresponding subnet mask.
2.
Alternatively, you can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z. Where the x’s represent the IP
address to be assigned to the IP interface named System and the z represents the corresponding number of subnets
in CIDR notation.
The IP interface named System on the
and subnet mask which can then
be used to connect a management s
d management agent.
Switch can be assigned an IP address
tation to the Switch’s Telnet or Web-base
Figure 1–3. Assigning an IP Address
In the above example, the Switch was assigned an IP address of 10.53.13.26 with a subnet mask of 255.0.0.0.
The system message Success indicates that the command was executed successfully. The Switch can now be
2
Summary of Contents for DGS-3100 SERIES
