107
Param
nfigured.
all –
Specifies all of the ports on the Switch.
default –
Returns all of the ports in the specified range to their
802.1x default settings.
port_control –
Configures the administrative control over the
authentication process for the range of ports. The options are:
•
force_auth
– Forces the Authenticator for the port to
become authorized. Network access is allowed.
auto –
Allows the port’s status to reflect the outcome of the
authentication process.
•
force_unauth –
Forces the Authenticator for the port to
become unauthorized. Network access will be blocked.
quiet_period <sec 0-65535> –
Configures the time interval between
authentication failure and the start of a new authentication attempt.
tx_period <sec 1-65535>
- Configures the time to wait for a
response from a supplicant (user) to send EAP Request/Identity
packets.
supp_timeout <sec 1-65535>
- Configures the time to wait for a
response from a supplicant (user) for all EAP packets, except for the
Request/Identity packets.
server_timeout <sec 1-65535>
- Configures the length of time to wait
for a response from a RADIUS server.
max_req <value 1-10>
– Configures the number of times to retry
sending packets to a supplicant (user).
reauth_period <sec 300-4294967295>
– Configures the time interval
between successive re-authentications.
enable_reauth [enable | disable] –
Determines whether or not the
Switch will re-authenticate. Enabled causes re-authentication of
users at the time interval specified in the Re-authentication Period
field, above.
eters
<portlist> –
A port or range of ports to be co
•
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20:
DGS3100# config 802.1x auth_parameter ports 1–20 direction both
Success.
DGS3100#
config 802.1x init
Purpose
To initialize the 802.1x function on a range of ports.
Syntax
config 802.1x init port_based ports [<portlist> | all]
Description The
config 802.1x init
command initializes the 802.1x functions on
a specified range of ports or for specified MAC addresses operating
from a specified range of ports.
Parameters
port_based
– Instructs the Switch to initialize 802.1x functions based
only on the port number. Ports approved for initialization can then be
specified.
Summary of Contents for DGS-3100 SERIES
