125
show arpentry
Purpose
To display the ARP table.
Syntax
show arpentry {ipif system | ipaddress <ipaddr> | static }
Description The
show arpentry
command displays the current contents of the
Switch’s ARP table.
Parameters
ipif system <ipif_name 12>
– The name of the IP interface, the end
node or station for which the ARP table entry was made, resides on.
ipaddress <ipaddr> –
The network address corresponding to the IP
interface name above.
static –
Displays the static entries to the ARP table.
Restrictions None.
Example usage:
To display the ARP table
:
DGS3100# show arpentry
ARP timeout : 150 Seconds
Interface IP Address MAC Address Type
------------- ---------------- ------------------------- ---------------
System 10.6.41.33 00:00:b0:07:07:49 dynamic
System 10.6.41.49 00:20:18:2a:56:18 dynamic
Total Entries = 2
DGS3100#
config arp_aging time
Purpose
To configure the age-out timer for ARP table entries on the Switch.
Syntax
config arp_aging time <value 1-65535 >
Description The
config arp_aging time
command sets the maximum amount of
time, in minutes, that an ARP entry can remain in the Switch’s ARP
table, without being accessed, before it is dropped from the table.
Parameters
time <value 1-65535>
– The ARP age-out time, in minutes. The
value may be in the range of 1-65535 minutes, with a default setting
of 20 minutes.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure ARP aging time:
DGS3100# config arp_aging time 30
Success.
DGS3100#
Summary of Contents for DGS-3100 SERIES
