DGS-3100 Gigabit Ethernet Switch Manual
Figure
In the above
rameter <username>,
the CLI returned the command:
l key was pressed to re-enter
the previou
config a
be entered
and the con
ommand
All command
function in this way. In additi
the help prompts are the same as
presented in this manual
angle
lue or character string. The < > can also
indicate a W
mber fo character allowed.
a command is entered that is unrecognized by the CLI, the top-level commands will be displayed under the
Available c
2–4. Using the Up Arrow to Re-enter a Command
example, the command config account was entered without the required pa
config account prompt. The up arrow cursor contro
s command (
fig account c
ccount) at the command prompt. Now the appropriate username can
re-executed.
s in the CLI
ord with nu
on, the syntax of
brackets < > indicate a numerical va
If
ommands: prompt.
Figure 2–5. Available Commands
The top-level
ands consist of co
commands require one or
more param
narrow the t
t? or config what? Where the
what? is the
For example, entering the show
meters, the CLI will then display all of the
possible next para
comm
eters to
mmands such as show or config. Most of these
op-level command. This is equivalent to show wha
next parameter.
command with no additional para
meters.
6
Summary of Contents for DGS-3100 SERIES
