DGS-3100 Gigabit Ethernet Switch Manual
146
which is defined by the Administrator. A maximum of eight (8)
enable method lists can be implemented on the Switch.
Parameters
<string 12>
- Defines the
authen_enable method_list_name
to be
created as a string of up to 12 alphanumeric characters.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To create a user-defined method list, named “Permit” for promoting user privileges to Adminstrator privileges:
DGS3100# create authen_enable method_list_name Permit
Success.
DGS3100#
config authen_enable
Purpose
To configure a user-defined method list of authentication methods
for promoting normal user level privileges to Administrator level
privileges on the Switch.
Syntax
config authen_enable [default | method_list_name <string 12>]
method { | radius | local_enable | none}
Description The
config authen_enable
command configures a user-defined list
of authentication methods for promoting normal user level privileges
to Administrator level privileges using authentication methods on the
Switch. Once a user acquires normal user level privileges on the
Switch, he or she must be authenticated by a method on the Switch
to gain administrator privileges on the Switch, which is defined by
the Administrator. A maximum of eight (8) enable method lists can
be implemented simultaneously on the Switch.
The sequence of methods implemented in this command will affect
the authentication result. For example, if a user enters a sequence
of methods like
– radius – local_enable,
the Switch will send
an authentication request to the first
host in the server
group. If no verification is found, the Switch will send an
authentication request to the second
host in the server
group and so on, until the list is exhausted. At that point, the Switch
will restart the same sequence with the following protocol listed,
radius
. If no authentication takes place using the
radius
list, the
local_enable
password set in the Switch is used to authenticate the
user.
Successful authentication using any of these methods will give the
user an “Admin” level privilege.
Parameters
default
– The default method list for adminstration rights
authentication, as defined by the user. The user may choose one or
more of the following authentication methods:
•
– Specifies that the user is to be authenticated
using the
protocol from the remote
server hosts
of the
server group
list.
•
radius
– Specifies that the user is to be authenticated using
the
RADIUS
protocol from the remote RADIUS
server hosts
of the RADIUS
server group
list.
Summary of Contents for DGS-3100 SERIES
