D-Link DGS-3100 SERIES Cli Manual Download

Page: 173 / 220

165

using a logical AND operational method, with the values the Switch
finds in the specified frame header fields.

Syntax

config access_profile profile_id <value 1-15> [add access_id
[auto assign | <value 1-255>] [ethernet {vlan <vlan_name 32> |
source_mac <macaddr 000000000000-ffffffffffff> |
destination_mac <macaddr 000000000000-ffffffffffff> | 802.1p
<value 0-7> | ethernet_type <hex 0x05dd-0xffff>} ports
<portlist> [permit {replace_priority <value 0-7> | rate_limit
<value 3500-1000000>} | deny]

Description The

config access_profile

command defines the rules used by the

Switch to either filter or forward packets based on the Ethernet part
of each packet header.

Parameters

profile_id <value 1-15>

– Specifies the access profile id to be

configured with this command. This value is assigned to the access
profile when it is created with the

create access_profile

command.

The lower the profile ID, the higher the priority the rule will be given.

add access_id <value 1-128>

–

Adds an additional rule to the

above specified access profile. The value specifies the relative
priority of the additional rule. Up to 128 different rules may be
configured for the Ethernet access profile.

•

auto_assign

– Configures the Switch to automatically assign

a numerical value (between 1 and 128) for the rule being
configured.

ethernet

– Specifies that the Switch examine only the layer 2 part of

each packet to determine if it is to be filtered or forwarded based on
one or more of the following:

•

vlan <vlan_name 32>

–

Specifies that the access profile

applies only to this previously created VLAN.

•

source_mac <macaddr>

–

Specifies that the access profile

applies only to packets with this source MAC address. MAC
address entries may be made in the following format:
000000000000-FFFFFFFFFFFF

•

destination_mac <macaddr>

–

Specifies that the access

profile applies only to packets with this destination MAC
address. MAC address entries may be made in the following
format: 000000000000-FFFFFFFFFFFF

•

802.1p <value 0-7>

–

Specifies that the access profile

applies only to packets with this 802.1p priority value.

•

ethernet_type <hex 0x05dd-0xffff>

–

Specifies that the

access profile applies only to packets with this hexadecimal
802.1Q Ethernet type value in the packet header.

ports <portlist> | all

- The access profile for Ethernet may be defined

for each port on the Switch. Up to 128 rules may be configured for
each port. Specifying

all

configures this rule for all ports on the

Switch.

permit

– Specifies that packets that match the access profile are

permitted to be forwarded by the Switch.

•

replace_priority

– Specifies the value to replace the 802.1p

default priority of a packet, which meets the criteria specified
previously in this command, before forwarding it on to the
specified CoS queue. Otherwise, a packet will have its
incoming 802.1p user priority re-written to its original value
before being forwarded by the Switch.

•

rate_limit <value 3500-1000000>

–

Specifies the rate limit