DGS-3212SR Layer 3 Gigabit Switch
config ports
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure the speed of port 3 to be 10 Mbps, full duplex, learning and state enable:
DGS-3212SR:4#config ports 1:1-1:3 speed 10_full learning enable state
enable
Command: config ports 1:1-1:3 speed 10_full learning enable state enable
Success.
DGS-3212SR:4#
show ports
Purpose
Used to display the current configuration of a range of ports.
Syntax
show ports {<portlist>} {description}
Description
This command is used to display the current configuration of a range
of ports.
Parameters
<portlist>
−
Specifies a range of ports to be configured. The port list
is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4
−
in numerical order.
description
– Enter this parameter to view the description of the port
previously set in the
config ports
command.
Restrictions
None.
Example usage:
To display the configuration of all ports on a standalone switch:
DGS-3212SR:4#show ports
Command show ports:
Port Port Settings Connection Address
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
------ -------- --------------------- --------------------- --------
15:1 Enabled Auto/Enabled Link Down Enabled
15:2 Enabled Auto/Enabled Link Down Enabled
27
Summary of Contents for DGS-3212SR
