DGS-3212SR Layer 3 Gigabit Switch
config syslog host
Parameters
all
−
Specifies that the command will be applied to all hosts.
<index 1-4>
−
Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
severity
−
Severity level indicator. These are described in the
following:
Bold font indicates that the corresponding severity level is
currently supported on the switch.
Numerical Severity
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
4 Warning: warning conditions
5 Notice: normal but significant condition
6 Informational: informational messages
7 Debug: debug-level messages
informational
−
Specifies that informational messages will be sent
to the remote host. This corresponds to number 6 from the list
above.
warning
−
Specifies that warning messages will be sent to the
remote host. This corresponds to number 4 from the list above.
all
−
Specifies that all of the currently supported syslog messages
that are generated by the switch will be sent to the remote host.
71
Summary of Contents for DGS-3212SR
