DGS-3224TGR Layer 2 Gigabit Ethernet Switch User’s Guide
4
The IP address may be set using the Command Line Interface
(CLI) over the console serial port as follows:
1.
Starting at the command line prompt
DGS-
3224TGR:4#
−
enter the commands
config ipif
System ipaddress
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy
. Where the
x
’s
represent the IP address to be assigned to the IP
interface named
System
and the
y
’s represent the
corresponding subnet mask.
2.
Alternaltively, you can enter
DGS3224TGR:4#
−
enter the commands
config ipif System ipaddress
xxx.xxx.xxx.xxx/z
. Where the
x
’s represent the IP
address to be assigned to the IP interface named
System
and the
z
represents the corresponding
number of subnets in CIDR notation.
The IP interface named System
on the switch can be assigned
an IP address and subnet mask which can then be used to
connect a management station to the switch’s Telnet or Web-
based management agent.
