DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
188
From
Use the drop-down menu to select from MAC Address, IPv4 Address or IPv6.
To
Use the drop-down menu to select from MAC Address, IPv4 Address or IPv6. When IPv6 is
selected the user can only enter the IPv6 source address or the IPv6 destination address at
any one time.
Action
Select
Permit
to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select
Deny
to specify the packets that match the access profile to be filtered.
Select
Mirror
to specify that packets that match the access profile are mirrored to a port
defined in the config mirror port command. Port Mirroring must be enabled and a target port
must be set.
Option
Use the pull down menu to select an option, the user can choose between
Rate Limiting
,
Change 1P Priority
,
Replace DSCP
and
Replace ToS Precedence
.
Apply To
Use the pull down menu to select an option, the user can choose between
Ports
,
VLAN
Name
or
VLAN ID
and enter the appropriate information.
Click
Apply
to implement changes made.
Access Profile List
Creating an access profile is divided into two basic parts. The first is to specify which part or parts of a frame the
Switch will examine, such as the MAC source address or the IP destination address. The second part is entering the
criteria the Switch will use to determine what to do with the frame. The entire process is described below in two parts.
To view this window, click
ACL > Access Profile List
as shown below:
Figure 6 - 2 Access Profile Lists
To add an ACL Profile, click the
Add ACL Profile
button, which, will display the window below. There are four
Access
Profile Configuration
pages; one for
Ethernet
(or MAC address-based) profile configuration, one for
IPv4
address-
based profile configuration, one for the
Packet Content
and one for
IPv6
. You can explore the four
Access Profile
Configuration
options by entering a Profile ID and Profile Name and using the radio button to select an ACL Type
and click
Select
. The user may remove all Access Profiles by clicking the
Delete All
button (This button will not clear
Address Binding ACL entries, which can only be deleted through the
IP-MAC Binding
window). The page shown
below is the
Ethernet Access Profile Configuration
page.
