DIR-620S
Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
Parameter
Description
Enable shaping
Move the switch to the right to limit the maximum bandwidth of the
wireless network. In the
Shaping
field displayed, specify the
maximum value of speed (Mbps).
Move the switch to the left not to limit the maximum bandwidth.
Broadcast wireless
network
If the switch is moved to the left, devices cannot connect to the
wireless network. Upon that the router can connect to another access
point as a wireless client.
Clients isolation
Move the switch to the right to forbid wireless clients of this
wireless network to communicate to each other.
Enable guest network
This function is available for the additional network. Move the
switch to the right if you want the devices connected to the
additional network to be isolated from the devices and resources of
the router's LAN.
In the
Security Settings
section, you can change security settings of the wireless network.
By default, the
WPA2-PSK
network authentication type of the wireless network is specified. WPS
PIN from the barcode label is used as the network key.
Figure 99. Network authentication types supported by the router.
The router supports the following authentication types:
Authentication type
Description
Open
Open authentication (with WEP encryption for wireless network
modes not supporting 802.11n devices).
WEP
Authentication with a shared key with WEP encryption. This
authentication type is not available when a mode supporting
802.11n devices is selected from the
Wireless mode
drop-down
list on the
Wi-Fi / Basic Settings
page.
WPA
WPA-based authentication using a RADIUS server.
Page
122
of 236
