DIR-620S
Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
In the opened window, you can specify the following parameters:
Parameter
Description
Protocol
An IP version.
Interface
From the drop-down list, select an interface (connection) through
which the device will communicate with the remote network. If you
have selected the
Auto
value, the router itself sets the interface
according to the data on the existing dynamic routes.
Destination network
A remote network which can be accessed with help of this route. You
can specify an IPv4 or IPv6 address.
The format of a host IPv6 address is
2001:db8:1234::1
, the
format of a subnet IPv6 address is
2001:db8:1234::/64
.
Destination netmask
For IPv4 protocol only.
The remote network mask.
Gateway
An IP address through which the destination network can be accessed.
Metric
A metric for the route. The lower the value, the higher is the route
priority.
Optional
.
After specifying the needed parameters, click the
SAVE
button.
To edit an existing route, select a relevant line of the table. In the opened window, change the
needed parameters and click the
SAVE
button.
To remove an existing route, select the checkbox located to the left of the relevant line in the table
and click the
DELETE
button (
).
Page
179
of 236
