DIR-620S
Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
Figure 155. The page for adding an IPsec tunnel. The window for adding a tunneled network.
In the opened window, you can specify the following parameters:
Parameter
Description
Local network
A local subnet IP address and mask.
Remote subnet
A remote subnet IP address and mask.
Сlick the
SAVE
button.
To edit fields in the
Tunneled Networks
section, select the relevant line in the table. In the
opened window, change the needed parameters and click the
SAVE
button.
To remove a subnet, select the checkbox located to the left of the relevant line in the table and click
the
DELETE
button (
). Also you can remove a subnet in the editing window.
After configuring all needed settings for the IPsec tunnel, click the
APPLY
button.
To edit the parameters of an existing tunnel, in the
Tunnels
section, select the relevant tunnel in
the table. On the opened page, change the needed parameters and click the
APPLY
button.
To remove an existing tunnel, select the checkbox located to the left of the relevant line in the table
and click the
DELETE
button (
). Also you can remove a tunnel on the editing page.
To disable VPN tunnels based on IPsec protocol, move the
Enable
switch to the left.
Page
193
of 236