DIR-820
AC1200 Wave 2 MU-MIMO Wi-Fi Router
User Manual
Configuring via Web-based Interface
In the opened window, you can specify the following parameters:
Parameter
Description
Enable
Move the switch to the right to enable the route.
Move the switch to the left to disable the route.
Protocol
An IP version.
Interface
From the drop-down list, select an interface (connection) through
which the device will communicate with the remote network. If you
have selected the
Auto
value, the router itself sets the interface
according to the data on the existing dynamic routes.
Destination network
A remote network which can be accessed with help of this route. You
can specify an IPv4 or IPv6 address.
The format of a host IPv6 address is
2001:db8:1234::1
, the
format of a subnet IPv6 address is
2001:db8:1234::/64
.
Destination netmask
For IPv4 protocol only.
The remote network mask.
Gateway
An IP address through which the destination network can be accessed.
Metric
A metric for the route. The lower the value, the higher is the route
priority.
Optional
.
Table
From the drop-down list, select a routing table for the route.
•
group_1
table is used to route user traffic.
•
main
table is used to route management traffic from internal
system services of the router.
After specifying the needed parameters, click the
SAVE
button.
To edit an existing route, select a relevant line of the table. In the opened window, change the
needed parameters and click the
SAVE
button.
To remove an existing route, select the checkbox located to the left of the relevant line in the table
and click the
DELETE
button (
).
Page
153
of 210
