D-Link Dis-200G Series, Quick Installation Manual

3

EN

G

LI

SH

Rear Panel Connectors

                Figure 5

#

Item

Description

1

Power input

This is used to connect an external power 

adapter to the switch.

Table 5

Top Panel Connectors

Figure 6

#

Item

Description

1

Switch ground

This is used to connect the switch to ground.

2

Terminal block

This is used to connect the switch to external 

power sources and relays.

Table 6

Hardware Installation

Before You Begin

Observe the following precautions to help prevent 

shutdowns, equipment failures, and personal injury:
•  Install the DIS-200G in a cool and dry place. Refer 

to the technical specifications in the user manual 

for the acceptable operating temperature and 

humidity ranges.

•  Leave at least 10 cm of space at the top, rear and 

bottom of the switch for ventilation.

•  Visually inspect the power connector and make 

sure that it is fully secured to the power cord.

•  Do not stack any devices on top of the switch.

It is also recommended that power and grounding 

requirements are investigated before mounting the 

DIS-200G, as access to the switch may be restricted 

once it has been installed.

For safety caution details, please refer the HW 

installation guide which can be acquired from CD 

in the package.

Caution! 

Hot surface! Do not touch!

PRUDENCE! 

Surface chaude! Ne pas toucher!

Mounting the Switch on a DIN Rail

Before beginning either mounting or removing the 

DIS-200G from a DIN rail, please ensure that the 

DIN rail is level and that the DIN rail mounting kit is 

installed correctly on the DIS-200G.
Use the following instructions to install the DIS-200G 

on a DIN rail:
1.  With the back of the DIS-200G facing the DIN 

rail, lower the top part of the rail mounting kit 

onto the DIN rail.

2.  Push the DIS-200G vertically down and rotate the 

bottom of the DIS-200G towards the DIN rail, to 

attach the switch to the DIN rail.

Use the following instructions to remove the 

DIS-200G from a DIN rail:
1.  Push the DIS-200G vertically down to create 

enough space at the bottom of the rail mounting 

kit to remove the DIS-200G from the DIN rail.

2.  Rotate the DIS-200G upwards to remove the 

bottom of the rail mounting kit from the rail, and 

lift the DIS-200G upwards to remove the whole 

of the switch from the DIN rail.

Mounting the Switch on a Wall

The DIS-200G can be installed on a solid surface by 

using the included wall mounting plates attached 

to the back of the switch. It can also be mounted 

using the in-built screw hooks on the underneath 

of the switch.

Using the Wall Mounting Brackets

Use the following instructions to install the DIS-200G 

on a wall:
1.  Remove the DIN rail mounting kit from the back 

of the DIS-200G (if present).

2.  Align the cross-section of the mounting plates 

with the openings on the back of the switch and 

secure the plates to the switch with the included 

screws.

1

2

1