D-Link DPH-70E, User Manual

DPH-70E User’s Guide 

19 

7.1 ISP 

Parameters 

DPH-70E needs to connect to the Internet to make Internet phone calls. The following information 
should be configured in DPH-70E to connect to the Internet and make calls. The user will get this 
information while subscribing to Internet Service Provider (ISP). Please note that DPH-70E will 
not work for Internet phone calls without this information. 
 

ISP Phone Number  

This is the phone number to which DPH-70E will dial-up to connect to the Internet. The Internet 
access phone number can be maximum 20 digits. If you enter more digits and try to save, you will 
hear a prompt “The parameter you have entered is incorrect, Press ‘1’ to edit, ‘2’ to skip”. Press 
‘1’ or ‘2’ appropriately.  
 
DPH-70E normally dials out with DTMF tones. However, if Internet access phone number is 
configured to start with a ‘$’, then the phone dials out in pulse mode.  
 
DPH-70E supports a mode called blind dialing mode. In this mode, DPH-70E won’t look for dial 
tone on line before dialing the ISP number. User can enter '&' (Ampersand) as first character in 
ISP Phone number (or as second character if first character is '$' for pulse mode dialing) for 
dialing ISP number in blind mode. 
 

Warning: In blind dial mode DPH-70E won’t prompt any error messages related to line conditions. 

 
DPH-70E has special supports for operation behind an EPABX. In some scenarios, you may 
have to introduce a delay after dialing external access number or wait for secondary dial tone. A 
‘.’ (dot) in phone number will introduce a delay and a  ‘_’ (under-score) will look for secondary dial 
tone. For example, 9.6788341 will introduce a small delay after dialing 9, before dialing other 
digits. 
 

ISP User Name  

The user name identifies the user to Internet Service Provider (ISP). It can have a mix of digits, 
lower and upper case letters, and special characters. The user name can have a maximum of 30 
characters. Please refer to Appendix A: Procedure for entering alphanumeric and special 
characters to enter special characters.  
 

ISP Password 

The password used for verifying the user to Internet Service Provider (ISP). It can have a mix of 
digits, lower and lower case letters, and special characters. It can have a maximum of 30 
characters. Please refer to Appendix A: Procedure for entering alphanumeric and special 
characters to enter special characters.  
 

7.2  Calling Card Parameters 

The following information is required for DPH-70E to make and receive Internet phone calls. The 
user will get this information from the VoIP (Internet Telephone) service provider. Please note that 
DPH-70E will not work for Internet phone calls before configuring this information. 
 

Calling Card User ID 

This is the Internet phone number or user ID assigned to you. It can have a maximum of 30 
characters. This information is required to verify the calling card user identity to the VoIP (Internet 
Telephone) Service Provider.