Section 3 – Web Configuration
27
Adding a PVC in
DHCP
mode, do as follow:
Step 1
Set the Default Route Selection to
Auto
.
Step 2
Input VPI/VCP value and select Encapsulation mode provided by your
ISP. The VPI/VCP value of the new PVC must be different from the
PVCs which exist in Current ATM VC Table.
Step 3
Set the channel mode to
1483 MER
.
Step 4
According to the internet service provided by your ISP, choose the
WAN connection type. For static IP user, choose
Fixed IP
. For
dynamic IP user, choose
DHCP
.
Step 5
If the Type is set to Fixed IP, enter the Local IP Address, Remote IP
Address, and Netmask provided by your ISP.
Step 6
After setting, click
Add
to add the new PVC in PPPoE mode in Current
ATM VC Table.
After adding a PPPoE PVC to the table, click
in the
PPPoE
mode, the page
shown in the below figure appears. In this page, you can modify parameters of
this PPPoE PVC.
