Section 3 – Web Configuration
34
Show Active
Clients
Click it to view the information of the wireless clients that
are connected to the modem.
Channel Width You can select
20MHZ
,
40MHZ or 20/40MHZ
.
Control
Sideband
Only when choose
40MHZ
for Channel Width, you can
set this parameter. You can choose
Upper
or
Lower
from
the drop-down list.
Apply
Changes
Click it to apply the settings temporarily. If you want to
save the settings of this page permanently, click
Save
in
the lower left corner.
Wireless Security
Choose
SETUP
>
Wireless Setup
>
Wireless Security
. The page is shown as the
figure appears on the right. In this page, you can configure the security for your
wireless network.
The following table describes the parameters of this page:
Field
Description
Encryption
Configure the wireless encryption mode. You can
choose
None
,
WEP
,
WPA (TKIP)
,
WPA (AES)
,
WPA2 (AES)
,
WPA2
(TKIP)
,
or
WPA2 Mixed
.
Wired equivalent privacy (
WEP
) encrypts data
frames before transmitting over the wireless
network.
Wi-Fi protected access (
WPA
) is a subset of the
IEEE802.11i security specification draft.
WPA2 Mixed
is the collection of WPA and WPA2
encryption modes. The wireless client
establishes a connection with the modem
through WPA or WPA2.
Set WEP Key
It is available when you set the encryption mode to
WEP
. Click it, the
Wireless WEP Key Setup
page
appears.
WPA Authentication
Select
Personal (Pre-Shared Key)
, enter the
