Section 3 - Configuration
D-Link DSL-2880AL User Manual
59
OUTBOUND FILTER
By default, all outgoing IP traffic from the LAN is not restricted. The Outbound Filter allows you to create a filter rule to block outgoing IP traffic by
specifying a filter name and at least one condition below. All of the specified conditions in this filter rule must be satisfied for the rule to take effect.
To access the
OUTBOUND FILTER
settings window, click on the
OUTBOUND FILTER
button in the
ADVANCED
tab
ADD OUTBOUND IP FILTER
To create the new policy and fill in the
filter name
.
Choose ICMP, TCP/UDP, TCP or UDP on the
Protocol
.
Type
Source IP address
,
Source Subnet Mask
and
Source Port
(can
be single port or port range in
“start port::end port” syntax )
Type
Destination IP address
,
Destination Subnet Mask
and
Destination Port
(can be single port or port range in
“start port::end port”
syntax )
Set the policy schedule on the Schedule, Always or never, or
View
Available Schedules
Please click
Add/Apply
button to add the policy in the list.
