Pre-Installation
This section explains how to physically connect the DSL-302G to your computer.
Before
you begin, visually inspect the rear of your computer and make sure it has either a USB
or Ethernet port as shown below. If you are uncertain as to the different type of ports,
please consult the manuals that came with your computer. If your computer does not
have one of the two ports, you need to purchase and install a USB or Ethernet adapter
before proceeding with the installation.
For USB:
• Your computer has a functional USB
port.
• Only for Microsoft Windows
98SE/Me/2K/XP Operating Systems.
For Ethernet:
• Your computer has pre-installed or built-in
Ethernet adapter.
• Can be used for all Operating Systems.
USB Port
Ethernet Port
USB Installation
(for Windows 98SE/Me/2K/XP)
For USB Installation, please continue to step
For Ethernet Installation, please continue to step
Insert the DSL-302G CD-ROM
into the computer. The following
auto-run screen will appear:
Click on
Install Drivers &
Utility
Requirements:
Make sure that your ADSL service is enabled. If you are not sure, please contact your
ISP to verify. Since both ADSL and your telephone service uses the same telephone line
wire, you are susceptible to noise and interference. To eliminate these noise, you must
use a micro-filter with all other telephony devices such as your telephone, fax machine,
and answering machine. Please refer to the Appendix at the end of this guide for more
information.
