D-Link DVG-3004S User Manual
60
usr/config$
Parameters Usage:
print out all current settings
-idtime
set the duration(in second) of two pressed digits in dial mode
as timed out. If after the duration user hasn’t pressed next
number, it will dial out all number pressed. (1-10 seconds)
-keypad
DTMF replay type. When value is “0”, Gateway will transfer
DTMF signal via In-Band type, “1” via RFC2833 type. Users
can adjust the value according to various applications.
1. number (instead of Line number of FXO Line)+ PSTN
number to make a call to PSTN side connected with FXO
Line.
2. After gateway-prefix-drop function is enabled, user must
remember to re-configure line number of FXS Line,
because line number of FXS Line must remove prefix
number. For example, origin line number of FXS line is
1001, prefix is 100, since prefix number will be drop, once
gateway has incoming call 1001, after drop gateway prefix
100, it will search line number “1”. So line number must be
set as “1”.
-ring
ring time for ring detection(in ms). When Gateway has
incoming call from PSTN side to FXO port, Gateway will
determine it is a ring but not noise only if it is longer than this
ring time.
Note:
In Taiwan the ring time of PSTN usually is 1000ms, so if user
set ring time longer that 1000ms, FXO port may not be able to
pick up the call from PSTN side.
-rba
When the calls from the PSTN side, FXO port will off hook if
the ring time is matched with this number.
-eod
It will transfer the DTMF in “#” if users disable the end of dial
function. Users have to press the key pad in “#” if the end of
dial function is enable.
-connect The unit will send the connect message to the IP side
automatically. This function just supports the
one-stage-dialing function.
