DVG-7022S/7044S/7062 User’s Manual
Telephony Settings
y
Enable:
To enable a line; if some lines are not used, disable them (Pause Function) to avoid unnecessary
waiting when an incoming call is diverting to this line.
Hotline Functions
y
FXS port:
When the user picks up the phone, the gateway automatically dials your assigned hotline number.
When in hotline mode, other phone numbers cannot be dialed.
y
FXO port:
When receiving a call from an outside line, the gateway will divert the call to the assigned hotline
number.
y
Hot Line No.:
Enter the hot line number for an automatic dialing function.
y
Warm Line:
When the Warm Line function is in use, user can dial a number. Otherwise the system will
divert incoming calls from an outside line to the Hot Line Number after a set wait time.
Example:
Assume the assigned hotline for DVG-7022S/7044S/7062S line 1 is 701 and the Warm Line (Hot Line Delay)
is 5 seconds. If no extension number is dialed within 5 seconds, the call will be automatically diverted to the
assigned hotline (ext 701). The system allows users to record a voice prompt (e.g. “please enter an
extension number or wait for the operator to content you”) to use in this situation.
Assume the assigned hotline for DVG-7022S/7044S/7062S line 2 is 702 and the wait time is 0 second.
When Port2 receives a call from an outside line, it will be automatically diverted to extension 702.
y
Dial-out Prefix:
It is the number dialed automatically by the system when the FXO interface diverts a call to
the PSTN by VoIP.
y
FXO Line Default Dial-Out:
Default number that FXO will dial out when it receive an incoming call from
VoIP.
Example:
If PBX extension needs to dial “0” to make a PSTN call, and the FXO ports are connected to PBX extension.
In this case, the Dial-out prefix should be set to “0”. If the PBX requires some delay time before capturing a
line, then the trunk prefix should be set as “0,” so that after dialing a 0, it will pause for 1 second before
dialing the destination number. Each comma represents a 1 second delay. If more delay time is required,
simply add more commas.
Please note that if a Dial-out prefix is set, the line won’t be able to dial any
PBX extension line.
D-Link Systems, Inc.
22