DVG-7022S/7044S/7062 User’s Manual
Gateway Configuration-IVR
Select a PPPoE
y
After entering IVR mode, dial 114.
y
After hearing “Enter value,” dial 3 (to select PPPoE).
PPPoE Account Settings
y
After entering IVR mode, dial 121.
y
After hearing “Enter value”, enter the account number followed by”#”.
Example
: If the account is “84943122@hinet.net,” please enter 08 04 09 04 03 01 02 02 71 48 49 54 45 60 72 54 45
60 #.
NOTE: it is necessary to enter two digits for each character/number; for example, you must enter
“01” for “1” and “11” for “A”. It is recommended that you use the web Interface to configure your
PPPoE account details. Refer to the PPPoE Character Conversion Table on the next page for key
mappings if you choose to use IVR setup.
PPPoE Password Setting
y
After entering IVR mode, dial 122,
y
After hearing “Enter value,” enter the new password followed by “#”.
Example
: If the password is “3ttixike”, please enter “03 60 60 49 64 49 51 45#”.
Save Settings and Restart
To save settings, dial
509
(Save Settings). The system will save the settings. Please restart the system.
Wait for about 40 seconds for the system to restart, then enter
101
to check whether or not the IP address
was retained. If the IP address is not repeated, this indicates that the gateway is not properly connected.
Please check to be certain that the cable connection, account, and password are all correct.
D-Link Systems, Inc.
76
