Using the add Command
D-Link
Unified Wired and Wireless Access System
November 7, 2011
Page 16
D-Link UAP CLI Command Reference
Using the add Command
The
add
command enables you to add a new instance or group of instances of a class and has the following
syntax:
add
unique-named-class instance
[
property value ...
]
add
group-named-class instance
[
property value ...
]
add
anonymous-class
[
property value ...
]
For example:
add mac-acl default mac
00:01:02:03:04:05
Using the remove Command
The
remove
command enables you to remove an existing instance of a class. It has the following syntax:
remove
unnamed-class
[
property value
. . . ]
remove
named-class instance
| all [
property value
. . .]
For example:
remove mac-acl default mac
00:01:02:03:04:05
Additional CLI Commands
The CLI also includes the following commands for maintenance tasks:
Note:
To add an instance to a uniquely named class, you must assign the instance a name that is not
already in use by another instance of that class. If you add instances to group-named classes, you can
form groups by creating instances and assigning them identical names. All instances of a group-named
class that have the same name form a group of instances.
Table 2: Additional CLI Commands
Command
Description
save-running
The
save-running
command saves the running configuration as the startup
configuration.
For more information, see
“Saving Configuration Changes” on page 21
.
reboot
The
reboot
command restarts the access point (a “soft” reboot).
factory-reset
The
factory-reset
command resets the AP to factory defaults and reboots.
firmware-upgrade
Use the
firmware-upgrade
command to upload a new AP image.
config
Use the
config
command to upload or download the AP configuration file.