SNMP Commands 317
7 Management Commands
Format
show snmptrap
Mode
Privileged EXEC
SNMP Trap Name
The community string of the SNMP trap packet sent to the trap manager.
The string is case sensitive and can be up to 16 alphanumeric characters.
IP Address
The IP address to receive SNMP traps from this device.
Status
The receiver's status (enabled or disabled).
show trapflags
This command displays trap conditions. Configure which traps the switch should generate by
enabling or disabling the trap condition. If a trap condition is enabled and the condition is
detected, the SNMP agent on the switch sends the trap to all enabled trap receivers. You do not
have to reset the switch to implement the changes. Cold and warm start traps are always
generated and cannot be disabled.
Format
show trapflags
Mode
Privileged EXEC
Authentication Flag
Can be enabled or disabled. The factory default is enabled. Indicates
whether authentication failure traps will be sent.
Link Up/Down Flag
Can be enabled or disabled. The factory default is enabled. Indicates
whether link status traps will be sent.
Multiple Users Flag
Can be enabled or disabled. The factory default is enabled. Indicates
whether a trap will be sent when the same user ID is logged into the switch
more than once at the same time (either through Telnet or the serial port).
Spanning Tree Flag
Can be enabled or disabled. The factory default is enabled. Indicates
whether spanning tree traps are sent.
Broadcast Storm Flag
Can be enabled or disabled. The factory default is enabled. Indicates
whether broadcast storm traps are sent.
ACL Traps
May be enabled or disabled. The factory default is disabled. Indicates whether
ACL traps are sent.
BGP4 Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether
BGP4 traps are sent. (This field appears only on systems with the BGPv4 soft-
ware package installed.)
DVMRP Traps
Can be enabled or disabled. The factory default is disabled. Indicates
whether DVMRP traps are sent.
OSPF Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether
OSPF traps are sent.
PIM Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether
PIM traps are sent.
Summary of Contents for DWL-8500AP
