![background image](http://html.mh-extra.com/html/d-link/dwm-311/dwm-311_user-manual_75785020.webp)
17
D-Link DWM-311 User Manual
Section 3 - Configuration
Rule is enabled:
Name:
Protocol:
Source MAC
address:
Source IP
address:
Source port:
External IP
address:
External Port:
If the port forward rule is enabled, click
Disable
to disable it. If
the rule is disabled, click
Enable
to enable it. Note that only one
button appears at a time.
Displays the current name assigned to the port forward and allows
the name to be changed.
Select the protocols affected by the port forward rule. Choose
TCP+UDP
,
TCP
,
UDP
,
ICMP
, or select
-- custom --
to enter a
protocol manually. This setting is required.
Allows the user to apply the rule based on the source MAC
address. Users can enter MAC addresses manually by selecting
-- custom --
. Users can add multiple MAC address by clicking the
button. Leaving this blank applies the rule to incoming packets
from all MAC addresses. This setting is optional.
Allows the user to apply the rule based on the source IP address
or source IP address range to apply the rule to. This setting is
optional. Leave blank to allow any IP.
Allows the user to apply the rule based on the port used by the
source of the packet. Note that this is not the same as the external
port. Leave this blank to forward packets from any source port.
Allows the user to apply the rule based on the external IP address
or “target IP address” of the packet. Leave this set to
any
to apply
the rule regardless of external IP address. The default setting is
any
.
Select the external port used by the incoming service. The
external port will be exposed directly to the internet. This setting
is required.
Port Forwards (Cont)
Edit a Port Forward