31
D-Link DWR-113 User Manual
Section 3 - Configuration
SNMP
Select
Enabled
to allow local SNMP
administration. Select
Disabled
to
disallow local SNMP administration.
Select
Enabled
to allow local SNMP
administration. Select
Disabled
to
disallow local SNMP administration.
Enter the password
public
in this
field to allow “Read only” access to
network administration using SNMP.
You can view the network, but no
configuration is possible with this
setting.
Enter the password
private
in this
field to gain “Read and Write” access
to the network using SNMP software.
Enter up to four IP addresses of any trap targets on your network.
Select the SNMP version of your system.
Click
Save Settings
to save your changes, or click
Don’t Save Settings
to discard your changes.
SNMP
SNMP Local:
SNMP Remote:
Get Community:
Set Community:
IP 1, IP 2, IP 3, IP 4:
SNMP Version:
SNMP
(Simple Network Management Protocol) is a widely used network monitoring and control protocol that reports activity on each
network device to the administrator of the network. SNMP can be used to monitor traffic and statistics of the DWR-113. The DWR-113
supports SNMP v1 or v2c.
