D-Link DWS-1008 User Manual
18
Changing the Maximum Default Power Allowed On a Radio
By default, the maximum power level that RF Auto-Tuning can set on a radio is the same as the maximum
power level allowed for the country of operation. To change the maximum power level that RF Auto-
Tuning can assign, use the following command:
set {ap
port-list
| dap
dap-num
} radio {1 | 2} auto-tune max-power
power-level
The power-level can be a value from 1 to 20.
To set the maximum power that RF Auto-Tuning can set on radio 1 on the access point on port 1 to 12
dBm, type the following command.
DWS-1008#
set ap 7 radio 1 auto-tune max-power 12
success: change accepted.
Locking Down Tuned Settings
You can convert dynamically assigned channels and power settings into statically configured settings,
by locking them down. When you lock down channel or power settings, MSS converts the latest values
set by RF Auto-Tuning into static settings.
You can lock down channel or power settings on a radio-profile basis. MSS implements the lock down
by changing the
set {ap | dap} radio channel or set {ap | dap} radio tx-power command for each
radio managed by the radio profile.
To lock down channel or power settings, use the following commands:
set radio-profile
name
auto-tune channel-lockdown
set radio-profile
name
auto-tune power-lockdown
To verify the static settings, use the
show {ap | dap} config command.
To save the locked down settings, you must save the switch’s configuration.
The following commands lock down the channel and power settings for radios in radio profile
rp2
:
DWS-1008#
set radio-profile rp2 auto-tune channel -lockdown
success: change accepted.
DWS-1008#
set radio-profile rp2 auto-tune power-lockdown
success: change accepted.
Summary of Contents for DWS-1008
Page 1: ......
