155
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuring DWL-8220AP Access Points
Changing Bias
The CLI commands described in this section enable you to change the bias for an AP. To
change the bias of a DWL-8220AP, use the following command:
set
{
ap
port-list
|
dap
dap-num
}
bias
{
high
|
low
}
The default bias is high.
To change the bias for a Distributed AP to low, type the following command:
DWS-1008#
set dap 1 bias low
success: change accepted.
Configuring a Load-Balancing Group
A load-balancing group is a named set of access points. MSS balances user sessions
among the access points in the group.
To assign an access point to a load-balancing group, use the following command:
set
{
ap
port-list
|
dap
dap-num
}
group
name
To configure a load-balancing group named
loadbalance1
that contains directly-connected
access points on ports 1, 4, and 6, type the following command:
DWS-1008#
set ap 1,4,6 group loadbalance1
success: change accepted.
Disabling or Reenabling Automatic Firmware Upgrades
An access point can automatically upgrade its boot firmware by loading the upgrade version
of the firmware from a switch when the AP is booting. Automatic firmware upgrades are
enabled by default.
To disable or reenable automatic firmware upgrades, use the following command:
set
{
ap
port-list
|
dap
dap-num
}
upgrade-firmware
{
enable
|
disable
}
Enabling LED Blink Mode
Blink mode makes a DWL-8220AP easy to identify. When blink mode is enabled, the health
and radio LEDs alternately blink green and amber. By default, blink mode is disabled. Blink
mode continues until you disable it. LED blink mode is disabled by default.
Changing the LED blink mode does not alter operation of the access point. Only the behavior
of the LEDs is affected.
Summary of Contents for DWS-1008
Page 1: ......