169
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuring DWL-8220AP Access Points
Disabling or Reenabling All Radios Using a Profile
To disable or reenable all radios that are using a radio profile, use the following command:
set radio-profile
name
[
mode
{
enable
|
disable
}]
The following command enables all radios that use radio profile
rp1
:
DWS-1008#
set radio-profile rp1 mode enable
success: change accepted.
The following commands disable all radios that use radio profile
rp1
, change the beacon
interval, then reenable the radios:
DWS-1008#
set radio-profile rp1 mode disable
success: change accepted.
DWS-1008#
set radio-profile rp1 beacon-interval 200
success: change accepted.
DWS-1008#
set radio-profile rp1 mode enable
success: change accepted.
Resetting a Radio to its Factory Default Settings
To disable an AP radio and reset it to its factory default settings, use the following
command:
clear
{
ap
port-list
|
dap
dap-num
}
radio
{
1
|
2
|
all
}
This command performs the following actions:
• Sets the transmit power, channel, and external antenna type to their default values.
• Removes the radio from its radio profile and places the radio in the default radio
profile.
This command does not affect the PoE setting.
To disable and reset radio 2 on the access point connected to port 3, type the following
command:
Summary of Contents for DWS-1008
Page 1: ......
