202
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuring RF Auto-Tuning
Changing RF AutoTuning Settings
Disabling or Reenabling Channel Tuning
RF AutoTuning for channels is enabled by default. To disable or reenable the feature for all
radios in a radio profile, use the following command:
set
radio-profile
name
auto-tune
channel-config
{
enable
|
disable
}
To disable channel tuning for radios in the
rp2
radio profile, type the following command:
DWS-1008#
set radio-profile rp2 auto-tune channel-config disable
success: change accepted.
Changing the Channel Tuning Interval
The default channel tuning interval is 3600 seconds. You can change the interval to a value
from 0 to 65535 seconds. If you set the interval to 0, RF AutoTuning does not reevaluate
the channel at regular intervals. However, RF AutoTuning can still change the channel in
response to RF anomalies. D-Link recommends that you use an interval of at least 300
seconds (5 minutes).
To change the channel tuning interval, use the following command:
set
radio-profile
name
auto-tune
channel-interval
seconds
To set the channel tuning interval for radios in radio profile
rp2
to 2700 seconds (45 minutes),
type the following command:
DWS-1008#
set radio-profile rp2 auto-tune channel-interval 2700
success: change accepted.
Changing the Channel Holddown Interval
The default channel holddown interval is 900 seconds. You can change the interval to a
value from 0 to 65535 seconds. To change the channel holddown interval, use the following
command:
set
radio-profile
name
auto-tune
channel-holddown
holddown
To change the channel holddown for radios in radio profile
rp2
to 600 seconds, type the
following command:
DWS-1008#
set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
Summary of Contents for DWS-1008
Page 1: ......
