205
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuring RF Auto-Tuning
Displaying RF AutoTuning Information
You can display the RF AutoTuning configuration, a list of RF neighbors, and the values of
RF attributes.
Displaying RF AutoTuning Settings
To display the RF AutoTuning settings that you can configure in a radio profile, use the
following command:
show radio-profile
{
name
|
?
}
Entering
show radio-profile ?
displays a list of radio profiles.
To display the RF AutoTuning and other settings in the
default
radio profile, type the following
command:
DWS-1008#
show radio-profile default
Beacon Interval:
100 DTIM Interval:
1
Max Tx Lifetime:
2000 Max Rx Lifetime:
2000
RTS Threshold:
2346 Frag Threshold:
2346
Short Retry Limit: 5
Long Retry Limit:
5
Long Preamble: no Allow 802.11g clients only:
no
Tune Channel: yes Tune Power:
no
Tune Channel Interval: 3600 Tune Power Interval:
600
Power Backoff Timer: 10 Channel Holddown: 300
Countermeasures:
none Active-Scan:
yes
WMM enabled:
yes
Service profiles: default-dot1x, default-clear
To display the RF AutoTuning settings that you can configure on an individual radio, use the
following commands:
show ap config
[
port-list
[
radio
{
1
|
2
}]]
show dap config
[
dap-num
[
radio
{
1
|
2
}]]
To display the RF AutoTuning and other individual radio settings on radio 1 of a directly
connected AP access port connected to port 2, type the following command:
DWS-1008#
show ap config 2 radio 1
Port 2: AP model: DWL-8220AP, POE: enable, bias: high, name: AP02
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel: 6
tx pwr: 1, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Summary of Contents for DWS-1008
Page 1: ......