213
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuring and Managing STP
213
D-Link Systems, Inc.
Changing the Bridge Priority
To change the bridge priority, use the following command:
set spantree priority
value
{
all
|
vlan
vlan-id
}
Specify a bridge priority from 0 through 65,535. The default is 32,768. The
all
option applies
the change globally to all VLANs. Alternatively, specify an individual VLAN.
To change the bridge priority of VLAN pink to 70, type the following command:
DWS-1008#
set spantree priority 70 vlan pink
success: change accepted.
Changing STP Port Parameters
You can change the STP cost and priority of an individual port, on a global basis or an
individual VLAN basis.
Changing the STP Port Cost
To change the cost of a port, use one of the following commands.
set spantree portcost
port-list
cost
cost
set spantree portvlancost
port-list
cost
cost
{
all
|
vlan
vlan-id
}
The
set spantree portcost
command changes the cost for ports in the default VLAN (VLAN 1)
only. The
set spantree portvlancost
command changes the cost for ports in a specific
other VLAN or in all VLANs. Specify a value from 1 through 65,535 for the cost. The default
depends on the port speed and link type.
The
all
option applies the change to all VLANs. Alternatively, specify an individual VLAN. To
change the cost on ports 3 and 4 in the default VLAN to 20, type the following command:
DWS-1008#
set spantree portcost 3,4 cost 20
success: change accepted.
To change the cost for the same ports in VLAN mauve, type the following command:
DWS-1008#
set spantree portvlancost 3,4 cost 20 vlan mauve
success: change accepted.
Resetting the STP Port Cost to the Default Value
To reset the STP port cost to the default value, use one of the following commands:
clear spantree portcost
port-list
clear spantree portvlancost
port-list
{
all
|
vlan
vlan-id
}
Summary of Contents for DWS-1008
Page 1: ......
