33
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuration (continued)
Configuration
Configuring for a Directly-Connected AP
Caution:
When you set the port type for use by locally connected APs, you must specify the
PoE state (enabled or disabled) of the port. If you enable PoE on a port connected to another
device, physical damage to the device can result.
To set a port for a locally-connected AP, use the following command:
set port type ap port-list
model {DWL-8220AP}
poe {enable | disable}
[radiotype {11a | 11b| 11g}]
You must specify a port list of one or more port numbers, the AP model number, and the PoE
state.
DWL-8220AP access points have a two radios; One radio is always 802.11a. The other
radio is 802.11b/g, but can be configured for 802.11b or 802.11g exclusively. If the country
of operation specified by the set system countrycode command does not allow 802.11g, the
default is 802.11b.
DWL-8220AP radios configured for 802.11g also allow associations from 802.11b clients
by default. To disable support for 802.11b associations, use the set radio-profile 11g-only
command on the radio profile that contains the radio.
The DWL-8220AP has an internal 802.1b/g antenna as well as a connector for an external
antenna, so use of an external antenna is optional on these models. It also has a connector
for an optional external 802.11a antenna. To specify the antenna model, use the set {ap |
dap} radio antennatype command.
To verify the configuration changes, use the following commands. Use
show ap config
for
directly connected APs and use
show dap config
for Distributed APs.
show ap config [port-list [radio {1 | 2}]]
show dap config [dap-num [radio {1 | 2}]]
Summary of Contents for DWS-1008
Page 1: ......
